Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Sensors/MEMS
?
?
Sensors/MEMS??

DoCoMo cuts handset BOM with RF MEMS

Posted: 17 Nov 2009 ?? ?Print Version ?Bookmark and Share

Keywords:MEMS? wireless handset? power amplifier?

MEMS technology is critical to the success of future of wireless handsets, according to a DoCoMo Research Laboratories executive.

In a presentation during the MEMS Executive Congress, Shoichi Narahashi made the case for using MEMS RF switches to simplify the BOM for future mobile handsets. Narahashi said a single, reconfigurable power amplifier chip could replace the four separate amplifier chips required today.

"Reconfigurable [power amplifiers] using MEMS RF switches have the potential to perform just as well as multiple PAs, but at a fraction of the cost and in a more compact form factor," said Narahashi.

DoCoMo showed its prototype design for a quad-band mobile handset that uses two sets of MEMS RF switches: one set to reconfigure a power amplifier to transmit at one of four different frequencies and another that switched in different filters to reconfigure the RF front-end to receive at one of four different frequencies.

Design strengths and weakness were described by Narahashi, but he did not reveal DoCoMo's MEMS supplier, if any.

"This was the first formal interaction NTT DoCoMo has had with the MEMS industry," said Karen Lightman, managing director of the MEMS Industry Group.

Narahashi claimed DoCoMo's prototype proved the concept, but it is up to MEMS vendors to demonstrate that low-cost RF switches can be fabricated with sufficient power-handling capability. Durability is also needed at a level that matches that provided by multiple amplifiers, he added.

- R. Colin Johnson
EE Times





Article Comments - DoCoMo cuts handset BOM with RF MEMS
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top