Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Interface
?
?
Interface??

DesignWare controller IP suits LTE, WiMAX apps

Posted: 06 May 2010 ?? ?Print Version ?Bookmark and Share

Keywords:MIPI? processor? interface? LTE? WiMAX?

Synopsys Inc. has is offering the DesignWare MIPI (Mobile Industry Processor Interface) 4G DigRF Master Controller IP compliant with the recently ratified MIPI DigRF v4 1.00 specification and enables designers to reliably implement the new standard.

In addition, Synopsys is developing the DesignWare M-PHY, the PHY for the MIPI DigRF v4 interface, in parallel with the ratification of the specification. A single-vendor solution enables designers to lower the risk and cost of integrating the DigRF interfaces into baseband ICs (BBICs) and application processors, while speeding time-to-market of advanced LTE and Mobile WiMAX SoCs.

MIPI Alliance's DigRF v4 is the latest generation of the standard that defines the interface between RF transceiver ICs and BBICs. It addresses the increased data throughput requirements for mobile terminals targeting 4G standard air interfaces such as LTE and Mobile WiMAX. The DigRF v4 specification also supports existing 3GPP standards such as 2.5G and 3.5G.

The low power and area-efficient DesignWare 4G DigRF Master Controller implements the features defined for the protocol and PHY adaptation layers of the DigRF v4 rev 1.00 specification. The DesignWare DigRF IP has also verified interoperability with RFIC devices currently available on the market. Configurability of the IP RTL provides flexibility for system-specific implementations, such as number of lanes, sublinks and diversity, while protocol-specific attributes including IQ sample size, frame scheduling and handling of timing critical signals are software programmable.

"Ratification of the DigRF v4 specification is a key achievement for the MIPI Alliance," said Joel Huloux, chairman of the MIPI Alliance. "As an active contributor to the MIPI working groups, Synopsys has direct influence on the specification which enables them to provide a comprehensive IP solution that will help speed the adoption of this new interface into the mobile market."

The DesignWare DigRF 4G controller is available now. The M-PHY is under development based on the evolving MIPI specification.

- Toni McConnel
Embedded.com





Article Comments - DesignWare controller IP suits LTE, ...
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top