Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Manufacturing/Packaging
?
?
Manufacturing/Packaging??

A*STAR: Aluminium–germanium sealant toughens MEMS

Posted: 01 Mar 2013 ?? ?Print Version ?Bookmark and Share

Keywords:MEMS sensor? aluminium-germanium? metal alloys?

A team of researchers at A*STAR Institute of Microelectronics has investigated a couple of metal alloys that could give micro-electromechanical system (MEMS) sensors better protection in the toughest environments. They wanted to find cheaper, more durable alternatives to the metal solders, such as gold-tin or copper-tin, which are typically used to seal the case.

Typical MEMS sensors measure temperature, pressure or vibration and they are hermetically sealed inside a strong metal casing to prevent air or moisture degrading the sensors' electronics. Vivek Chidambaram and his co-workers tested a 70:30 aluminium-germanium mixture, which has a melting point of about 420C. This temperaturethe eutectic pointis much lower than that for either metal on its own.

Unlike most conventional packaging materials, aluminium and germanium are compatible with the processes used to manufacture the MEMS. Using the aluminium-germanium sealant should make MEMS manufacturing easier and cheaper, and could also improve the device's performance, noted Chidambaram.

The researchers built a stack of 4 alternating wafers of aluminium and germanium, each less than a micrometre thick, and heated the sandwich under pressure to about 400C for two hours. Although the wafers did not liquefy, this "thermal ageing process facilitated bonding prior to melting," said Chidambaram. Raising the temperature to 475C for another two hours fully melted the mixture, which then formed a strong seal after coolinga process known as transient liquid-phase bonding.

Next, the researchers used acoustic microscopy, scanning electron microscopy and X-ray spectroscopy to reveal any voids or other defects in the seals. They found that the thermal ageing process improved the quality of the seal. Tests showed that it was strong enough to withstand a shear of 46 megapascalssimilar to the pressure exerted by almost half a ton per square centimeterand was impermeable to water. The material lost little of its strength after being exposed to 300C for hundreds of hours.

Chidambaram and his team also tested a platinum-indium sealwhich has the highest re-melting point (894C) of all the solders being considered for these applicationsbut it lost its strength after long durations at 300C, leaving the aluminium-germanium mixture in pole position as a better seal for MEMS. "Cost effectiveness, better thermo-mechanical properties, and its eutectic microstructure makes it an attractive alternative," concluded Chidambaram.





Article Comments - A*STAR: Aluminium–germanium sealant...
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top