Global Sources
EE Times AsiaWebsite
Stay in touch with EE Times Asia
Emerging markets Home?/?eeForums?/?Talk Shop?/?Emerging markets
All about new geographical markets and growing engineering opportunities.
Hot Post Recommend
Post new message? Print ?thread
Message:?

SCADA concepts Trends in SCADA

Posted:? Nov 6, 2008 1:40 PM
?

Author:szsunyuan

Level:? Interns

Points:? 172

Send Message

Systems concepts

SCADA is an acronym that stands for Supervisory Control and Data Acquisition. SCADA refers to a system that collects data from various sensors at a factory, plant or in other remote locations and then sends this data to a central computer which then manages and controls the data.

SCADA is a term that is used broadly to portray control and management solutions in a wide range of industries. Some of the industries where SCADA is used are Water Management Systems, Electric Power, Traffic Signals, Mass Transit Systems, Environmental Control Systems, and Manufacturing Systems.

Trends in SCADA
There is a trend for PLC and HMI/SCADA software to be more "mix-and-match". In the mid 1990s, the typical DAQ I/O manufacturer supplied equipment that communicated using proprietary protocols over a suitable-distance carrier like RS-485. End users who invested in a particular vendor's hardware solution often found themselves restricted to a limited choice of equipment when requirements changed (e.g. system expansions or performance improvement). To mitigate such problems, open communication protocols such as IEC870-5-101/104 and DNP 3.0 (serial and over IP) became increasingly popular among SCADA equipment manufacturers and solution providers alike. Open architecture SCADA systems enabled users to mix-and-match products from different vendors to develop solutions that were better than those that could be achieved when restricted to a single vendor's product offering.
Towards the late 1990s, the shift towards open communications continued with individual I/O manufacturers as well, who adopted open message structures such as Modbus RTU and Modbus ASCII (originally both developed by Modicon) over RS-485. By 2000, most I/O makers offered completely open interfacing such as Modbus TCP over Ethernet and IP.
SCADA systems are coming in line with standard networking technologies. Ethernet and TCP/IP based protocols are replacing the older proprietary standards. Although certain characteristics of frame-based network communication technology (determinism, synchronization, protocol selection, environment suitability) have restricted the adoption of Ethernet in a few specialized applications, the vast majority of markets have accepted Ethernet networks for HMI/SCADA.

Signal Sensors IC special for SCADA System

SCADA to realize data acquisition,measurement,and other signal alarm functions,it have to collect pressure,temperature,humiditity,displacement sensors signal,isolated and convert.Based as described below:

Part No.:ISO4-20mA

ISO 4-20mA Current Loop Isolation Interface IC provides signal receive and transmittal on a single chip. The ceramic hermetic hybrid package contains an electromagnetic coupled converter and current modulate. The very low input equivalent impendence allows the input voltage up to a ultra-wide range,so that it is able to meet the requirements for no distortion in long-distance signal transmission under the circumstance of no outside connecting power. The internal ceramic PCB, printed impendence and new isolation technologies allow the IC for the 3KVAC insulated voltage and meets the industrial level for the extremely poor temperature, humidity and shaking conditions.

Download datasheet:

http://www.szsunyuan.com/sy/upload/200792941930845.pdf

Part No.:ISO4-20mA-F

?ISO 4-20mA-F is 4-20mA Signal Dual Loop Isolation Distributor ICit belongs to SUNYUAN? ISO -20mA series. The IC contains an electromagnetic coupled converter and current modulate, and a high fficiency DC-DC circuit and so on. The IC supplies to loop distributor 16V~21.5V, and meets requirements for -20mA loop sensor signal measurement, transmission, isolation and so on.,it can save energy and prevent xploding.The IC output is designed according to Loop circuit power supply of 24VDC and resistance onnecting in series, it match to popular module input attachment board, PLC and DCS or the other equipment module input attachment. The internal ceramic PCB, printed impedance and new isolation technologies allow he IC for the 3KVAC insulated voltage and meets the industrial level for the extremely poor temperature, humidity and shaking conditions.

Download datasheet:

http://www.szsunyuan.com/sy/upload/200891951049737.pdf

Part No.:ISO4-20mA-P

Download datasheet:

http://www.szsunyuan.com/sy/upload/20077241074453.pdf

Part No.:ISO1003

Download datasheet:

http://www.szsunyuan.com/sy/upload/200841657497761.pdf

Part No.:ISOEM-U(A)-P-O

? DC Current/Voltage Single/Dual Signal Isolated Amplifier IC

?

Download datasheet:

http://www.szsunyuan.com/sy/upload/20085458521157.pdf

Part No.:SY-ISO-R-P-O

? POTENTIOMETER SIGNAL TRANSMITTER

?

Download datasheet:

http://www.szsunyuan.com/sy/upload/20087438037753.pdf

Part No.:DIN1x1 ISO U(A)-P-O

DC V/I Signal converter to Frequency Signal Transducer?

Download datasheet:

http://www.szsunyuan.com/sy/upload/20087437271173.pdf

?

Reply with quote? Reply? Watch? Comment?
EETimes Asia : 44W silicon switch cuts power, size for cellular systems
(2)

Reply: SCADA concepts Trends in SCADA

Posted:? May 30, 2011 9:32 PM
?

Author:Visitor 3700

sir, what about plc,scada for future.i interested in that but i know little bit information.so please kindly inform about plc&scada.
Reply with quote? Reply? Comment?
Post new message
Previous thread????Where do Vietnam engin...
DC V/I Signal converte...????Next thread??
Quick Reply
*??Nickname: Visitor (To avoid code verification, simply login or register with us. It is fast and free!)
*??Message title:
*??Comment:
*??Enter verification code::
The engineering community needs are best served with a professional environment at eeForums. And we need your help in ensuring eeForums best serves your needs. Please report offensive or irrelevant messages/replies by clicking here. Thank you for your help and participation!
Return to Emerging markets | Talk Shop
The views and opinions shared on eeForums and eeBlogs are those held by users of the web site and do not represent those of EE Times Asia. EE Times Asia is not liable or responsible for any defects, deficiencies, errors, omissions or inaccuracies in any information, data or other content (whether provided or offered therein or in or through eeForums and eeBlogs).
How to earn points
The moderator marks your post as one of the following.
  • Good: +5 points
  • Very good: +10 points
  • Excellent: +20 points
  • Bad: -5 points
  • Very bad: -10 points
  • Exceptionally bad: -20 points

We also count your replies to questions posted by others.
  • You have posted 10 or more replies: +10 points
  • You have posted 20 or more replies: +50 points
  • You have posted 50 or more replies: +100 points
  • You have posted 100 or more replies: +200 points
Have Your Say!

Bloggers Say

Got something to say? Why not share it with other engineers?

Just introduce yourself to us, we'll contact you and set you up. Yes, it's that simple!

See what engineers like you are posting on our pages.

Interviews & Viewpoints

Talk

Learn how senior executives are seeing the industry from interviews and contributed opinions.

Back
?
Back to Top