Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Processors/DSPs
?
?
Processors/DSPs??

In-amp specifies differential output

Posted: 01 May 2006 ?? ?Print Version ?Bookmark and Share

Keywords:Instrumentation amplifiers? in-amps? op amps? ADC? Analog Devices Inc.?

Instrumentation amplifiers (in-amps) are specialized, precise-gain op amps with a challenging task: They take a low-level input signal, such as an EEG or strain gage, which is accompanied by a large amount of common-mode noise, and extract that signal. These amps increasingly have to provide differential-drive output to the next stage in the signal chain, typically an ADC.

Such differential signals are preferred because they provide increased immunity to on-board and inter-IC common-mode noisea consequence of nearby digital signals being aggravated by the reduction in supply voltages. Differential signals also provide 6dB greater dynamic range and signal-to-noise ratioboth critical specscompared with single-ended operation.

The in-amp specialists at Analog Devices Inc. repeatedly got "push-back" from designers, said product manager Scott Pavlik, who had to use two in-amps and configure the pair to provide a differential output, or use a single in-amp followed by a conventional, precision op amp for the single-ended-to-differential conversion. With either approach, however, final performance and common-mode rejection ratio (CMRR) are not specified by the vendor, but instead are a function of the design, layout and other factors. So why not produce an in-amp that is specifically designed and specified for differential output?

ADI considered doing a single-channel differential-output in-amp, said Pavlik, but "saw a better opportunity" in the AD8222, a dual-input in-amp with two independent channels. The two channels, housed in a package no larger than a single-channel device, can be configured by the user as a single-channel input, differential-output in-amp with guaranteed specs. The IC promises at least 80dB CMRR out to 10kHz and a 3dB bandwidth of 825kHz (both at gain of 1), which Pavlik said is 40dB higher than competing solutions, but in a package that is 60 percent smaller.

By putting two devices based on the established single-channel AD8221 on a single die, the dual device increases channel density. That makes it attractive for handheld systems, where package size is critical, and industrial applications, where channel counts are high.

It's not all about low-level signals, either. Many of the legacy and still-critical applications, such as industrial designs, use dual and relatively wide supply rails, such as 15Vdc, added Pavlik. So the in-amp must operate from those rails and also provide a wide output swing to the ADC, or else suffer loss in effective resolution. For this reason, the AD8222 is designed to operate from 2.3V to 18V supplies.

Housed in a 4-by-4mm lead-free chip-scale package, the in-amp sells for $3.59 each in lots of 1,000. It is sampling now.

- bill schweber
EE Times




Article Comments - In-amp specifies differential output
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top