Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
EE Times-Asia > Manufacturing/Packaging

Carbon nanotubes find, fix aircraft wing defects

Posted: 03 Oct 2007 ?? ?Print Version ?Bookmark and Share

Keywords:embedded carbon nanotubes? polymer composites? self-healing?

Carbon nanotubes can find and fix defects in aircraft wings and other polymer composites. This was shown by researchers at the Rensselaer Polytechnic Institute in New York. Carbon nanotubes mixed into an epoxy coating enabled a matrix of embedded wires to initiate self-healing repairs in structure surfaces. The added weight is a mere 1 percent of the polymer composite's total weight.

"The really novel part of our technique is that nanotubes are used to both detect and repair cracks that otherwise might grow to affect the structural integrity of an aircraft wing or other polymer composite," said RPI professor Nikhil Koratkar.

Finding cracks
A carbon nanotube-laced epoxy surface treatment was applied over an embedded wire matrix that forms an x-y grid over the entire surface. By scanning through the grid with a signal probe, tiny cracks can be detected. Cracks were sensed as a higher resistance when a probe signal had to travel a longer distance around a crack to complete a circuit.

Once a cracked region is identified, self-healing was initiated by passing a higher-current pulse through the nanotubes laced into the cracked region. The embedded nanotubes provided the electrical conductivity required to heat that region with a short, but high-current, pulse. Heat-activated healing agents mixed into the epoxy then flowed into the crack to stop its growth and recover 70 percent of the structure's original strength.

Commercially available healing agents can seal and recover most of the strength lost due to nanometer- or even micron-sized cracks in polymer composites. However, identifying the source and location of a crack remains a problem.

Healing cracks
RPI's method solves the problem by allowing every square inch of a wing to be scanned for defects before each take off. If cracks are detected, they can be repaired immediately by merely increasing the level of the electrical signal to that region, thereby melting the embedded healing agents. The technique can also detect and repair less common forms of structural damage such as delamination of polymer composite layers.

The RPI team is also developing software that can automatically scan structures for cracks, delamination and other defects and repair them in real time using controlled high-current pulses. They are also characterizing the degree to which the embedded carbon nanotubes--which are 1,000-times stronger that steel--inhibit the development and growth of small cracks in polymeric composites.

- R. Colin Johnson
EE Times

Article Comments - Carbon nanotubes find, fix aircraft ...
*? You can enter [0] more charecters.
*Verify code:


Visit Asia Webinars to learn about the latest in technology and get practical design tips.

Back to Top