Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Power/Alternative Energy
?
?
Power/Alternative Energy??

Understanding power issues in SDI products (Part 1)

Posted: 25 Jul 2011 ?? ?Print Version ?Bookmark and Share

Keywords:serial digital interface? SDI? jitter? eye timing?

Broadcast video products continue to push the boundaries of performance, many beyond the published industry standards. There are a broad range of components required to design a product that meets the numerous industry requirements like jitter, eye timing and signal rise/fall, to mention a few. Each component in the video signal path can have an impact on the product's performance. The analog and mixed-signal serial digital interface (SDI) componentsCsuch as cable equalizers, cable drivers, reclockers, serializers and deserializers (Ser/Des)Cform a critical portion of the video signal path.

They have power requirements, specifically for VCC voltage ripple, that are often understated or misunderstood with regards to their impact on SDI video quality. Focus on this design parameter can make the difference between a product whose performance is acceptable and exceptional. This article will discuss the issues and related tradeoffs that VCC ripple has on the performance of these video components.

image name

Figure 1: Sample SDI block diagram.

The VCC ripple specification for SDI components like those shown in figure 1 is typically not found in the device's product datasheet because the ripple limitations depend on a particular product's specific performance needs.

For example, what video data rates will be supported? What cable length (cable reach) is required at the product input? Meeting the product design specification requires managing the imposed jitter at each stage of the SDI signal path.

The VCC ripple on an SDI component can have a direct impact on the jitter and therefore, the resulting product performance. Designers of SDI components make every attempt to make their devices tolerant to power supply ripple and noise. However, understanding the VCC ripple requirements for these devices and the associated performance tradeoffs is still an important consideration. This is especially true for 3G data rates and newer components which enable long cable reaches.

Cable equalizers
The cable equalizer (EQ) is the receive component in the SDI signal path and provides both amplification for and restoration of the incoming video signal. A 3G video signal can be attenuated by as much as 50dB on a 180m length

of cable (Belden 1694A). That means a signal with 800mV of amplitude, at the cable driver, would be reduced to about 3mV after 180m of cable at the input of the EQ. The signal to noise ratio (SNR) plays a key role in powering a 3G EQ like the LMH0394 and LMH0395 (dual output), which can restore a signal after 180-200m of cable loss.

image name

Figure 2: VCC Ripple requirements for SDI equalizers.


1???2?Next Page?Last Page



Article Comments - Understanding power issues in SDI pr...
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top