Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
EE Times-Asia > Optoelectronics/Displays

Machine vision for automated LCD display testing

Posted: 17 Jun 2015 ?? ?Print Version ?Bookmark and Share

Keywords:dead pixels? LCD displays? sensors? Machine Vision? Vision Option?

Checking for dead pixels on LCD displays can be quite challenging. Visual inspection can take about a minute as you have to cycle through having on all the reds, all the greens, all the blue pixels and then all on together as white, while checking every time to try and spot dead pixels.

The human eye soon tires of this and dead pixels are then missed.

Obviously, an automated system is the solution but we could not find an off the shelf solution, so we had to build a Machine Vision-based one using a camera and Vision Option software from National Instruments to detect dead pixels.

The first question was whether or not to test the incoming displays from the supplier or to test them once assembled into products or at both stages. Doing both would have doubled the costs as two sets of cameras and optics would have been required along with two software licences.

We therefore decided that the most cost effective solution was to test the assembled product at the functional test stage, as this would highlight both any faults in the display's pixels and any faults that had occurred in the assembly of the control electronics.

This would result in a simple pass or fail for each unit. A fail could be broken into two types. Random pixel failures meant that the display had dead pixels and would be sent back to the supplier. Groups of pixel failures in certain patterns meant that the control electronics had a fault for us to fix.

However, when we set this all up, the camera showed strange coloured patterns, which meant that it was impossible to work out if any pixels were malfunctioning. These are Moir patterns caused by the lines of sensors in the camera's CCD optically interacting with the lines of pixels in the display.

Even the slightest difference between the line-up of the two sets of parallel lines resulted in Moir patterns. A common example of the Moir effect is a bridge over a motorway where the vertical railings on the near and far sides create a changing pattern as you drive towards the bridge.

Figure 1: Moir patterns.

Getting rid of the Moir effect was a major challenge. There are two variables. The first is the distance between the camera and the display as this affects the relative spacing of the lines and the second is the amount of angle offset between the two, i.e. rotating the camera relative to the display means that the interference between the lines changes.

1???2?Next Page?Last Page

Article Comments - Machine vision for automated LCD dis...
*? You can enter [0] more charecters.
*Verify code:


Visit Asia Webinars to learn about the latest in technology and get practical design tips.

Back to Top