Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
?
EE Times-Asia > Power/Alternative Energy
?
?
Power/Alternative Energy??

Selecting step-up/down voltage regulator for portable apps

Posted: 12 Apr 2016 ?? ?Print Version ?Bookmark and Share

Keywords:LDOs? battery? voltage? power source?

One of the popular power sources for portable devices is a single lithium-ion cell with 4.2V at full charge and 2.8V at end of discharge. However, some functions within portable electronics, such as a SIM card and DSP, require 2.8V and 3.3V. These are normally provided by low noise LDOs. The LDOs inputs (VCC) must be at a slightly higher voltage than the highest LDO output. Hence, VCC ends up right in the middle of the lithium-ion battery's range of operation. The use of a step-up/down voltage regulator, capable of operating from an input that can be higher or lower than the output, becomes necessary. Figure 1 shows the battery voltage (VBAT) as the power source for a typical portable design.

Figure 1: LDOs input voltage set by a Step-Up/Down converter.

In portable applications the voltage regulator efficiency is of the utmost importance, since higher efficiency translates into longer untethered operation. In this article we will review the available options, compare their performance, and determine the most efficient solution.

Bypass-boost
One way to solve the problem is to use a bypass-boost converter, namely a boost converter with an extra "pass" transistor integrated between the power source, VBAT, and the LDO input, VCC. Figure 2 shows the bypass-boost power train architecture and its operation table. Here the bypass transistor T3 accomplishes a "poor man's" step-down operation.

Figure 2: Bypass-Boost power train and operation table.

This architecture can only regulate VBAT voltages lower than the set VCC = 3.4V. For VBAT > 3.4V the boost converter stops regulating and the pass transistor turns on, directly connecting VBAT to VCC. Figure 3 shows the battery profile discharging over time and the LDO input voltage for the bypass-boost architecture.

Figure 3: LDOs input voltage profile with Bypass-Boost operation.

For the majority of the time (VBAT > 3.4V) the pass transistor in the bypass-boost architecture literally "passes the buck" to the LDOs downstream. The LDOs bear the task of regulating the high VBAT value down to their output set values. Since this regulation is linear the result is high power dissipation inside the LDO. This results in greater energy consumption and also requires a board design and IC selection capable of dissipating this energy.

Buck-boost
In contrast to the bypass-boost architecture, a buck-boost converter used in this circuit will never stop regulating its output to 3.4V. In addition, the regulation is entirely switch mode, which provides high efficiency operation. Figure 4 shows the buck-boost power train architecture and its operation table.

Figure 4: Buck-Boost power train and operation table.


1???2?Next Page?Last Page



Article Comments - Selecting step-up/down voltage regul...
Comments:??
*? You can enter [0] more charecters.
*Verify code:
?
?
Webinars

Seminars

Visit Asia Webinars to learn about the latest in technology and get practical design tips.

?
?
Back to Top