Global Sources
EE Times-Asia
Stay in touch with EE Times Asia
EE Times-Asia > Advanced Search > application note

application note What are application notes? Search results

?
?
What are application notes?
Application notes refer to instuctions and recommendations from the vendor provided in addition to the normal reference manuals.
total search6467 articles
2009-03-20 Using the DLL Phase Offset Feature in Stratix II and HardCopy II Devices
This application note describes how to implement the delay-locked loop (DLL) phase offset feature with Altera's Stratix II and HardCopy II devices.
2009-03-09 Using the capacitive sensing module on the PIC16F72X
This application note describes the use of the capacitive sensing module present on all PIC16F72X devices.
2008-09-15 Using Standard Power over Ethernet controllers for high-powered devices
Any IEEE 802.3af power sourcing equipment (PSE) power controller can be used for higher power by adding a simple circuit to the port to increase available current.
2007-08-21 Using op amps as comparators
This document by ADI's James Bryant summarizes the reasons and warns of possible unexpected consequences of using an op amp as a comparator.
2008-05-26 Using nvSRAM in single board computer (SBC) applications
The flexibility of fast non-volatile memory for the storage of user- or application-specific parameters is apparent with each new system generation, and the Cypress family of fast nvSRAMs are ideally suited for this type of application
2009-02-09 Using high-performance DDR, DDR2, and DDR3 SDRAM with SOPC Builder
The Altera DDR, DDR2, and DDR3 SDRAM high-performance controller MegaCore functions version 7.1 and later support SOPC Builder.
2009-02-09 Using HI-TECH C and a timer to interface mid-range PIC MCUs with UNI/O serial EEPROMs
This application note is intended to serve as a reference for interfacing Microchip's mid-range family of PIC MCUs with Microchip's UNI/O bus 11XXXXX family of serial EEPROM devices.
2008-09-10 Using external data memory with PIC24F/24H/dsPIC33F devices
This application note describes the methodology to use the Parallel Master Port (PMP) module to interface with external data memory; either external flash or external RAM
2001-03-30 Using DAQ event messaging under Windows NT/95/3.1
This application note describes how to use the DAQ Event Messaging subsystem of the NI-DAQ 4.4.1A Application Programming Interface (API) under the Windows NT/95/3.1 operating system.
2009-03-02 Using Copyback operations to maintain data integrity in NAND flash devices
Copyback operations, which are sometimes referred to as Internal Data Move operations, play a key role in maintaining data integrity in the NAND flash device.
2008-12-17 Using C30 and a timer to interface dsPIC33 DSCs and PIC24 MCUs with UNI/O bus-compatible serial EEPROMs
As embedded systems become smaller, a growing need exists to minimize I/O pin usage for communication between devices. Microchip has addressed this need by developing the UNI/O bus, a low-cost, easy-to-implement solution requiring only a single I/O pin for bidirectional communication.
2008-12-16 Using C to interface Texas Instruments' MSP430XXXX MCUs with SPI serial EEPROMs
This application note offers designers a set of examples for the read and write functions for the Microchip SPI Serial EEPROM using GPIO pins to simulate the SPI bus.
2008-06-25 Using C to interface 8051 MCUs with SPI serial EEPROMs
This application note is part of a series that provides source code to help the user implement the protocol with minimal effort. Here, Alexandru Valeanu offers a reference for interfacing 8051-based MCUs with Microchip's 25XXX series serial EEPROM devices, without the use of a hardware module.
2008-09-09 Using C and I/O pins to interface 8051 MCUs with I?C serial EEPROMs
This application note is intended to serve as a reference for interfacing 8051-based MCUs with Microchip's I?C 24XXX series serial EEPROM devices, without the use of a hardware module.
2008-10-31 Using C and a hardware module to interface Texas Instruments' MSP430XXXX MCUs with SPI serial EEPROMs
The 25XXX series serial EEPROMs from Microchip Technology support a half-duplex SPI protocol.
2009-03-11 Using block floating-point in the WOLA filterbank coprocessor
This application note describes the block floating-point scheme used in the WOLA filterbank coprocessor to preserve numeric precision in time-frequency transform.
2008-06-12 Using ASM and a hardware module to interface 8051 MCUs with I?C serial EEPROMs
This application note is part of a series that provide source code to help the user implement the protocol with minimal effort.
2008-09-08 Using a timer to interface 8051 MCUs with UNI/O bus-compatible serial EEPROMs
As embedded systems become smaller, a growing need exists to minimize I/O pin usage for communication between devices. Microchip has addressed this need by developing the UNI/O bus, a low-cost, easy-to implement solution requiring only a single I/O pin for bidirectional communication.
2008-08-25 Using a scope's segmented memory to capture signals more efficiently
Some oscilloscopes have a feature called "segmented memory" (sometimes known as sequential single shot memory), which can help you capture more of the active signal information.
2009-03-04 Using a Micron CellularRAM device with the AMCC PPC405EZ embedded processor
This technical note focuses on the asynchronous/page/burst, 128Mb, CellularRAM 1.5-compliant device, MT45W8MW16B
2008-08-27 Using a keyboard with the Microchip Graphics Library
The Microchip Graphics Library simplifies the design of a keyboard-based GUI, as this application note will demonstrate.
2008-06-25 Using a hardware module to interface 8051 MCUs with SPI serial EEPROMs
This application note is intended to serve as a reference for interfacing 8051-based MCUs using a hardware module with Microchip's 25XXX series serial EEPROM devices. The provided source code is written in assembly language.
2008-05-26 USB-powered battery charger for NiCd/NiMH batteries
The charger described in this application note by Svyatoslav Paliy, application engineer with Cypress Semiconductor, can easily be incorporated into computer peripherals.
2009-02-11 USB human interface device class on an embedded host
With the introduction of Microchip's microcontrollers with the USB on-the-go peripheral, microcontroller applications can easily support USB embedded host functionality.
2008-10-10 USB 2.0 PCB guidelines for the ArcticLink solutions platform
This document provides guidelines for component placement and PCB routing of the USB 2.0 portion of the QuickLogic ArcticLink Solutions Platform.
2008-04-25 USB 2.0 board design and layout guidelines
This application note from Texas Instruments discusses schematic guidelines when designing a universal serial bus system.
2008-08-29 Unifying RISC and DSP
The Hyperstone E1-32XSR core represents a unique microprocessor architecture: The combination of a high performance RISC processor with an additional powerful DSP instruction set and on-chip MCU functions.
2008-08-07 Understanding MSP430 flash data retention
The MSP430 family of MCUs, as part of its broad portfolio, offers both ROM-based and flash-based devices. Understanding the MSP430 flash is extremely important for efficient, robust, and reliable system design.
2008-10-15 Understanding loop compensation with monolithic switchers
Monolithic switchers, such as members of the NCP101X or the NCP1027 series, associate a current-mode controller and a power MOSFET on a single-die construction.
2009-03-16 Understanding drivers and direct I/O
This application note answers common questions about the use of drivers and direct I/O to send commands from a PC application to the test instrument.
Bloggers Say

Bloggers Say

See what engineers like you are posting on our pages.

?
?
Back to Top